1871
General Mach Discussion / Re: Setting Up Z Touch Probe WithOut Using The BIG-TEX BlueScreen
« on: November 20, 2014, 05:36:53 PM »
SUre set your code up as a Macro that uses parameters such as M1000 Q.85 The Q value is your offset height.
Then from your Post you just add the line
M1000 Q0.85 when you need to reference the tool offset. Then Mach3 will RUN the macro and set your tool offset to 0.85.
Just a thought, (;-) TP
Then from your Post you just add the line
M1000 Q0.85 when you need to reference the tool offset. Then Mach3 will RUN the macro and set your tool offset to 0.85.
Just a thought, (;-) TP