5691
General Mach Discussion / Re: Motor problem
« on: October 24, 2012, 07:11:46 AM »
Hi Saiz,
I understand what you are asking but you would need 'servo controllers' to drive your motors and 'encoders' to provide the feedback position of their shafts in order to control their movements and this would cost a lot of cash.
Tweakie.
I understand what you are asking but you would need 'servo controllers' to drive your motors and 'encoders' to provide the feedback position of their shafts in order to control their movements and this would cost a lot of cash.
Tweakie.