Topics

1

HiCON Motion Controller / No analog output from Hicon Integra

« on: April 16, 2018, 08:43:53 PM »

Cannot get 0-10 Vdc output from Hicon board

2

HiCON Motion Controller / Mach 4 And Hicon Motion Control With Automation Technologies KL-8070 Driver

« on: July 16, 2017, 04:03:34 PM »

Recently purchased the Hicon control board and got it installed. I set up 1 e-stop on my main panel that seems to function fine. After doing the Mach 4 config. And the Hicon config. I can't get any motion out of my motors. when i hit the execute button I can see that it is trying to move by looking at the commanded position but the motor will not rotate? The drive has the green power light lit up on it and as far as I can tell it is enabled. The board automatically disarms after it has reached the max error. I. Know motors and everything is wired right because I have had these motors running off of an ethernet smoother board. Any help on this would be much appreciated!