4991
General Mach Discussion / Re: Connection The Relay and Mach3 LED(Anti Dive for Plasma THC)
« on: May 26, 2013, 06:18:06 AM »
Ok if you go to Operator menu you will see Brain Editor, click that and the editor will open. Put in a name in the box, maybe AntiDive then the brain will be ready for editing.
Click the + and you will get a list of options appear, choose LED then choose from the list the option you want, looks like its 70 No Plunge THC, you then click OK. Next make sure you have highlighted that new box on the screen and press the + again you can then choose the No Operation (Pass Signal ) option. Once done then again press OK then click that box and then this time press the green symbol that resembles an upside down T. In the box that now appears you can choose output and then from the list choose the output number you wish to set up as your output signal. Click Ok then go to edit and click save then close the brain.
Next step if Operator menu and Brain Control, you will need to press Reload All Brains and then you should see your AntiDive in the list, click it then place a tick in Enabled then press reload Brain. That is it now set up and the only other thing you will need to do is go into ports and pins and set the correct port and pin number for your chosen output.
Now as previously mentioned I dont know a lot about plasma so I only assume that it is the LED above that is the signal indicator you are requiring.
Hood
Click the + and you will get a list of options appear, choose LED then choose from the list the option you want, looks like its 70 No Plunge THC, you then click OK. Next make sure you have highlighted that new box on the screen and press the + again you can then choose the No Operation (Pass Signal ) option. Once done then again press OK then click that box and then this time press the green symbol that resembles an upside down T. In the box that now appears you can choose output and then from the list choose the output number you wish to set up as your output signal. Click Ok then go to edit and click save then close the brain.
Next step if Operator menu and Brain Control, you will need to press Reload All Brains and then you should see your AntiDive in the list, click it then place a tick in Enabled then press reload Brain. That is it now set up and the only other thing you will need to do is go into ports and pins and set the correct port and pin number for your chosen output.
Now as previously mentioned I dont know a lot about plasma so I only assume that it is the LED above that is the signal indicator you are requiring.
Hood