19971
General Mach Discussion / Re: X axis will not change direction during cut
« on: March 01, 2009, 10:13:37 AM »
If your driver test is bad it will cause you problems but not sure if direction change would really be one, usually just very rough motors and missing steps etc.
You may need to change the Active state for your direction and step pulses, I am not familiar with these drives so dont know which way they should be set.
If it is noise I would say it is more likely to be on your Dir wire from BOB to drive, do you have shielded wires for ytour Step/Dir to the motor?
Hood
You may need to change the Active state for your direction and step pulses, I am not familiar with these drives so dont know which way they should be set.
If it is noise I would say it is more likely to be on your Dir wire from BOB to drive, do you have shielded wires for ytour Step/Dir to the motor?
Hood