2861
General Mach Discussion / Re: Mach3 with SmoothStepper Hardware Remote Start and Stop
« on: March 20, 2019, 01:51:13 PM »
Hi,
the script editor is Operator/VB Script Editor per attached.
You will have to run it as a macro pump to continuously sample your remote input.
You might alternately use a 'Brain', ladder logic programming. Mach3 programming is not my forte.
I could do this with less than a dozen lines of code in Mach4 Signal Library table, no PLC script required.
Craig
the script editor is Operator/VB Script Editor per attached.
You will have to run it as a macro pump to continuously sample your remote input.
You might alternately use a 'Brain', ladder logic programming. Mach3 programming is not my forte.
I could do this with less than a dozen lines of code in Mach4 Signal Library table, no PLC script required.
Craig