Messages

2101

General Mach Discussion / Re: How to unlink Rapid Rate from Feed Rate Override

« on: October 21, 2006, 04:37:26 PM »

There is not a way at this time

2102

General Mach Discussion / Re: Mach to DeskCNC?

« on: October 14, 2006, 11:58:30 PM »

They are in testing only  at this time once the software is done you should be able to get one.

Thanks
Brian

2103

Galil / Re: Mach3 + Galil

« on: October 14, 2006, 07:58:34 PM »

Art is working on doing a 2120 and i am doing an 1880 (I think)


So you can do both

2104

LazyCam (Beta) / Re: inf lazycam 2.64 mach3 rc2.0.g

« on: October 14, 2006, 07:54:46 PM »

Don't know what to tell you.. I can get it to break 

Could you post the file and your XML?

Thanks
Brian

2105

LazyCam (Beta) / Re: inf lazycam 2.64 mach3 rc2.0.g

« on: October 14, 2006, 04:30:53 PM »

There is work being done on it now

2106

General Mach Discussion / Re: "Solution too complex in Advanced Comp" message

« on: October 14, 2006, 04:20:45 PM »

That is niose do you have an external Feedhold button?

2107

General Mach Discussion / Re: Mach to DeskCNC?

« on: October 14, 2006, 04:15:22 PM »

They are in and are starting to get the code put them

I woudl think a few weeks...

2108

General Mach Discussion / Re: Using a Contour Design Shuffle as a pendant

« on: October 14, 2006, 04:06:57 PM »

There is a button that will set the center button from vel mode to inc mode... please put that button as one of the silver buttons that you have and I think is will work for you

2109

General Mach Discussion / Re: Using a Contour Design Shuffle as a pendant

« on: October 12, 2006, 03:18:30 PM »

I set up the two outer buttons (the black ones) to be rapid and the otter dial set to about 20% slow jog and the center as inc at .001. this makes for VERY fast movement and positioning.

hope that helps
Brian

2110

VB and the development of wizards / Re: some new extra turn wizards

« on: October 12, 2006, 01:35:43 PM »

Thank you for the work that you have done!