1
General Mach Discussion / Stop and start spindle using Mach 3
« on: November 03, 2008, 11:29:49 PM »
Hi .
I want to start and stop my spindle from G code program using mach 3 mill , I have a C11 breakout board from cnc4pc and the spindle motor is connected from that relay Pin 1. What do I need to set up in Mach 3 spindle set up to get this to work.
Regards
Eric
I want to start and stop my spindle from G code program using mach 3 mill , I have a C11 breakout board from cnc4pc and the spindle motor is connected from that relay Pin 1. What do I need to set up in Mach 3 spindle set up to get this to work.
Regards
Eric