Hi all
Now A am getting really frustrated.
Thanks Chip for the cleanup files bud of course I also made my own files to see and learn from all yours and others input.
I made A dxf that is respectable (removed allmost all splines and changed in to arcs , loaded in Lazycam , rearranged all paths to cut in the wanted order , rearranged all chains in A few layers , made offset on all items and I may say it went perfect including the right wing.
So far so good bud A man has to sleep sumtimes , so saved my work (did that of course also in between), went to sleep , wake up , go to work , come home and with good faith start to edit again to make the cutdephts and the tabs.
To make A short story long , I opened the lcam file and found out that in the layer ONDIEP all the entities and chains are gone except one chain and one entitie.
If I enable the layer (on the picture ONDIEP) all entities are shown in the drawing bud not in the list and I can set the depth of cut so i think I rescue my project bud that's all I can do with it.
This is real frustrating.
I have the lcam file included.
I also included the tap file I made.
If you run the tap file you see also one of the reasons why I want to move entities to another chain.
It cuts to one mm in more steps bud now each entitie is cut at a time and not as A chain what take Allot of time moving up and down.
Greetings:
Willem