111
General Mach Discussion / Re: Problems with ver. ...062 on WinXP
« on: August 08, 2018, 07:18:27 AM »Do you think I need this line also in codes which I generate in Vectric´s V-carve? If so, are there any ways to add this line automatically every time I create new codes with that program?
You should be able to edit the post processor in Vectric to put the G91.1 in. If you are not sure how to do that then the other option is to change the default in Mach. As said though code can change the IJ mode so I prefer to have it in the code itself as you always know even if Mach is defaulted to the opposite the code will still run correctly.
The setting is on the General Config page (from Config menu)