531
General Mach Discussion / Re: Mach3, Opt Laser 5W and Aspire
« on: February 24, 2021, 01:37:10 PM »I control the spindle speed through mach3?yes, but you control it by using the 0-10V Signal, or am i wrong?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I control the spindle speed through mach3?yes, but you control it by using the 0-10V Signal, or am i wrong?
Do you mean yes but still have to build Tweakies board?
but then you have to use two profiles or Change pin assignment in Config -> Port's and Pin's ->Motor Outputs ->can pin 14 be used where my spindle is usually connected?Yes.
can pin 14 be used where my spindle is usually connected?Yes.
btw. are you using the relay on your BOB?
Remind me where to check that?
This is what they said earliersorry i overread this, that's bad, because the only way in Mach3 is to use M10/M11 for fast switching laser,
"Set the adapter back to program 0, then enable inputs are not used. inputs is mostly for advanced use.
This will solv the problem."
When I run some gcode I get 4.95v between pin 3 & 4 with it wired pin 8 10k resistor from 5v to pin 8 on bobthat's like it should be M11P1 is switching Output and Output gives the 5v to Enable Input 1.