5331
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
To get back to the subject of slaving one axis to another.
direct quote from another source:
"In Mach, go to config->ports and pins->motor outputs. Change the check mark or x in the "Dir LowActive" column so it is opposite between X and the slaved A axis. This will cause the motors to be slaved together, but to rotate in opposite directions, which is required since they are mirrored in position to one another."
Can I interpret the 1/2"-10, 5 start acme screw's lead screw pitch (mcmaster-carr says 1/2" travel per turn) into metric format namely 12.7mm per turn.
I know you can setup different profiles in a Mach3 installation, but do they allow you to run more than one machine?