1361
Brains Development / Re: External switch to activate custom m code
« on: March 29, 2013, 01:56:33 PM »
Over and over if single shot is unchecked. Edited my last reply too......
Brett
Brett
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
What Great folks there are on this forum! Hey Chaoticone, pm sent.
Rick
When I put the reading pins to pin 2 & 3 and I try to jog the voltage reading jumps from 5.18 to 5.17-5.16
Once you have that sorted set up pins 2 and 3 for the x axis motor. Put your meter leads between pins 3 and the one to the left of it 5V/G and see if you get a reading. Try jogging the x axis in both directions with your meter in place. You should see your reading change when you change directions. Look at your x axis dros in machs run screen and see if it counts up and down as you jog in different directions (right and left arrow keys jog the x axis).
Brett