Messages

1611

General Mach Discussion / Re: parameter syntax

« on: January 25, 2015, 01:18:54 AM »

#5 = [#2-2]

1612

Mach4 General Discussion / Re: Screen Set Ideas

« on: January 25, 2015, 12:51:11 AM »

OK I found the problem. FINALLY

YOU HAVE to include a MIN and a MAX size to the box. all I had was a MAX.


OK Now the next thing to try and do is to create a BUTTON to do an OPTIONAL sort of the tool table based on DIAMETER and have it Smallest to largest order.

(;-) TP

1613

Mach4 General Discussion / Re: Screen Set Ideas

« on: January 25, 2015, 12:18:37 AM »

Well I thought I had it BUT it will only go to about 3/4 screen size and that is it. No matter what settings I try. So there is something else hanging it up and keeping it from expanding full size.

(;-) TP

1614

Mach4 General Discussion / Re: Screen Set Ideas

« on: January 24, 2015, 10:29:25 PM »

OK I found what I did wrong I left in the defaultsize calls and there was a conflict.

Thanks Craig I owe you one, (;-) TP

1615

Mach4 General Discussion / Re: Screen Set Ideas

« on: January 24, 2015, 09:14:14 PM »

OK That worked with a new dialogbox  BUT did NOT work using it with the TOOL TABLE example.

I am using it to LEARN more.  I can manipulate most of everthing there BUT I cannot size the BOX to size NOR Resize the FONT.

Thanks for the help, THIS is going to be VERY painfull and require Many cups of coffee.

(:-) TP

1616

Mach4 General Discussion / Re: Screen Set Ideas

« on: January 24, 2015, 07:02:48 PM »

Does anyone know HOW to expand the WX dialog box to full screen size ? I ran into this with wizards as well. 

(;-) TP

1617

Mach4 General Discussion / Re: GSim Mach4 Material Removal Simulator

« on: January 24, 2015, 07:01:13 PM »

I have a LIST, 

(;-) TP

1618

Mach4 General Discussion / Re: GSim Mach4 Material Removal Simulator

« on: January 24, 2015, 04:30:26 PM »

Great Idea Art. I really LIKE your tool table section I am working on something for MAch4 that is similar.

(;-) TP

1619

General Mach Discussion / Re: how mach3 recognize the drawing

« on: January 24, 2015, 04:17:15 PM »

Mach 3 cannot do it that way. It was never designed to do it in that manner.

What you need is torchmate software. IT does it that way.

(;-) TP

1620

General Mach Discussion / Re: Rotational speed

« on: January 23, 2015, 05:04:49 PM »

HUM, that is not right.  You have to set the rotary axis to the PROPER  steps per as defined by your hardware setup . I think you will find that in DEMO mode the axis rotational correction does not work.  IF your steps per are TOO HIGH you will NEVER get the required speed to match the XY axis in feedrate. The A will only go so fast.

IF you need speed in the rotary you need to change out the hardware to the proper ratios for speed.

Just a thought, (;-) TP