6681
General Mach Discussion / Re: Z axis help
« on: July 26, 2011, 04:53:35 AM »
Hi Isaac,
I am not an expert here but it seems that it is just the way it turns out.
With Z 0.000 being the top surface of the work (individually set for each job) then the Safe Z setting within Mach is a positive number as is all the Z Clearance figures calculated by the software I use. It just seems tidy that way.
Tweakie.
I am not an expert here but it seems that it is just the way it turns out.
With Z 0.000 being the top surface of the work (individually set for each job) then the Safe Z setting within Mach is a positive number as is all the Z Clearance figures calculated by the software I use. It just seems tidy that way.
Tweakie.