Hello Guest it is May 17, 2024, 05:25:52 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Jog working but not step  (Read 747 times)

0 Members and 1 Guest are viewing this topic.

Offline JohnHaine

*
  • 810 810
    • View Profile
Re: Jog working but not step
« Reply #10 on: May 02, 2024, 08:26:09 AM »
Well, I'm out of suggestions, sorry!
Logged

Offline nimbusgb

*
  • 8 8
    • View Profile
Re: Jog working but not step
« Reply #11 on: May 02, 2024, 09:20:08 AM »
Thanks anyway!
Logged

Offline Graham Waterworth

*
  • *
  • 2,684 2,684
  • Yorkshire Dales, England
    • View Profile
Re: Jog working but not step
« Reply #12 on: May 02, 2024, 11:19:01 AM »
Are you running in demo mode or with a licence file?
Logged
Without engineers the world stops

Offline nimbusgb

*
  • 8 8
    • View Profile
Re: Jog working but not step
« Reply #13 on: May 02, 2024, 11:27:27 AM »
licenced.
Logged

Offline Graham Waterworth

*
  • *
  • 2,684 2,684
  • Yorkshire Dales, England
    • View Profile
Re: Jog working but not step
« Reply #14 on: May 02, 2024, 11:32:46 AM »
Is it the one you used with the Novosun board?
Logged
Without engineers the world stops

Offline nimbusgb

*
  • 8 8
    • View Profile
Re: Jog working but not step
« Reply #15 on: May 03, 2024, 06:26:44 AM »
Nope, A restored backup copy. I never did get the Novusun working properly.
Logged

Offline TPS

*
  • 2,506 2,506
    • View Profile
Re: Jog working but not step
« Reply #16 on: May 03, 2024, 01:05:50 PM »
i would rename the mach3 directrory and do a brand new mach3 installation.
then put in the few parameters in Config -> Motor tuning for all axis,
just have a look for these parameters in the existing installation.


 
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Pages: « 1 2   Go Up
« previous next »