1811
General Mach Discussion / Re: New CV features
« on: December 14, 2006, 08:25:20 PM »
Hi, Scott
Thanks for the photos nice work.
As far as the problems go, I didn't mention.
Have you try-ed setting the LookAhead value down in Config. General Logic.
Setting the Step & Dir Pulse up some in Motor Tuning, some stepper cards need this.
Change the Dir & Step Low Active to opposite state in Ports & Pins, Motor Outputs, some stepper cards need this also.
You can Reverse Axis Direction in Home & Limits page (Reverse box), Its really the proper place to do this, well in My opinion.
May-be one of these will Help, Chip
Thanks for the photos nice work.
As far as the problems go, I didn't mention.
Have you try-ed setting the LookAhead value down in Config. General Logic.
Setting the Step & Dir Pulse up some in Motor Tuning, some stepper cards need this.
Change the Dir & Step Low Active to opposite state in Ports & Pins, Motor Outputs, some stepper cards need this also.
You can Reverse Axis Direction in Home & Limits page (Reverse box), Its really the proper place to do this, well in My opinion.
May-be one of these will Help, Chip