8681
General Mach Discussion / Re: M6T" tool change sequence does not load tool # in DRO
« on: May 14, 2012, 04:00:39 PM »
Ha ha I can remember when I was first retrofitting my lathe. I did the ladder in the PLC here at home and as I was used to Mill (and wasnt keen on the Turn screen). I was using it to test out the sequence in the ladder (switches connected to PLC for simulation). It worked perfectly. I then made a new screenset up for turn but I couldnt get the ladder to work in the PLC and it took me a wee while to work out why, I had been calling M6T* instead of T****, so you are not the only one
Hood
Hood