13011
General Mach Discussion / Re: Run from here... possible bug
« on: January 29, 2011, 07:28:31 PM »
Russ, you are testing with a licenced version I presume?
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
However it was not suitable for my gang setup (and I suspect most gang tool setups). The problem I had in the gang setup was, when a tool whose centreline was located, say, 100mm from the Master Tool position was selected, the cross slide would try to travel to a position beyond the X+ limits before returning to the correct position.
Regards
Chrisjh