5651
G-Code, CAD, and CAM discussions / Re: G41/G42 failure and BUGGIE Mach3
« on: March 23, 2009, 09:35:08 PM »
Can you post some code that gives you trouble, and what version of mach3 you're currently running. While Mach's comp code was a little buggy in the past, with care it could be worked around at times.
The current development version of mach3 has updated cutter comp code that appears to work much better. Although as it's a development version, it may have other issues.
I don't have a Tormach, but from what I've read, they like to use a much older version of mach3 than is usually available, to alleviate support problems in their end.
The current development version of mach3 has updated cutter comp code that appears to work much better. Although as it's a development version, it may have other issues.
I don't have a Tormach, but from what I've read, they like to use a much older version of mach3 than is usually available, to alleviate support problems in their end.