Messages

101

Mach4 General Discussion / Re: How do I disable fixture offset (after reference all axes)?

« on: May 16, 2022, 03:10:58 PM »

Thats it.
you can remove it from the left up or comment out the code

102

Mach4 General Discussion / Re: TouchOff UI pushes into table after touch

« on: May 11, 2022, 06:10:49 PM »

This might not be it but some of the manufacturers need a ground wire to the bit to make a good ground connection.
Run a ground wire to the bit and see if it works better.

103

Mach4 General Discussion / Re: How do I disable fixture offset (after reference all axes)?

« on: May 09, 2022, 04:12:22 PM »

Go to Configure then Control.
Click on the Homing/Softlimits tab
Do you have any values in the Home Offset for x and y?

104

Mach4 General Discussion / Re: How do I disable fixture offset (after reference all axes)?

« on: May 09, 2022, 04:09:24 PM »

Not usual behavior at all as far as i know.
Go to Configure then Control
On the right side of the Defaults tab is a section Initialization Codes.
Put G53 in it to be in machine coordinates.

105

Mach4 General Discussion / Re: How do I disable fixture offset (after reference all axes)?

« on: May 09, 2022, 03:59:18 PM »

Well i am lost.
I can not see where it would actually move.

106

Mach4 General Discussion / Re: How do I disable fixture offset (after reference all axes)?

« on: May 09, 2022, 02:14:33 PM »

While in Screen Edit Mode click on the Reference all Axes button.
Under Properties on the left click the middle icon.
What is in the Left Up Script?

107

Mach4 General Discussion / Re: How do I disable fixture offset (after reference all axes)?

« on: May 09, 2022, 01:58:37 PM »

It would not call G54 it would have a move command.
I do not see it in the code.
Are you positive it is moving after a Reference All Home?

108

Mach4 General Discussion / Re: How do I disable fixture offset (after reference all axes)?

« on: May 09, 2022, 12:53:59 PM »

Make a copy of your Mach4Hobby folder in case you mess something up before editing the screen.
If it is moving to the G54 position after a Reference All Home it is in the function RefAllHome() in the Screen Load Script.
You will need to edit the Screen Load Script
Go to Operator then Edit Screen
Under the Screen Tree Manager click the top listed wx4
Under properties select the middle icon (Events)
Next to Screen Load Script click on the words to the right then the button with 3 dots
Find RefAllHome and make your edits.
After your edits go to Screen then Save Screen.
Go to Operator then Edit Screen to exit screen edit mode.

109

Mach4 General Discussion / Re: Mach 4 DRO Reading Incorrectly

« on: May 03, 2022, 08:09:55 AM »

Just so I understand correctly.
You have it set up so 1 step is equal to 1"?

110

Mach4 General Discussion / Re: Auto Tool changer from Mach3 to Mach 4

« on: April 25, 2022, 09:40:28 AM »

As far as I know there is no easy way.
They are totally different.
You will need someone to change it for you or do it yourself.
Here is a document if you want to do it yourself to help you get started.
https://www.machsupport.com/forum/index.php?topic=45397.msg289143#msg289143