3421
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: August 13, 2016, 03:40:37 AM »
Hi Ted, welcome to the forum.
There are far too many reasons for the problems you are experiencing to list them all but this is just my thoughts...
The 'pulsing too fast' can be caused by something on the PC running in the background such as USB hub, printer driver, memory stick etc.
Ideally the PC running Mach3 should be a 'dedicated PC' with no other software (other than Mach3 related) installed.
The shutdown could be related to your graphics card.
Perhaps check that your PC meets the minimum requirements mentioned here; http://www.machsupport.com/software/mach3/
Tweakie.
There are far too many reasons for the problems you are experiencing to list them all but this is just my thoughts...
The 'pulsing too fast' can be caused by something on the PC running in the background such as USB hub, printer driver, memory stick etc.
Ideally the PC running Mach3 should be a 'dedicated PC' with no other software (other than Mach3 related) installed.
The shutdown could be related to your graphics card.
Perhaps check that your PC meets the minimum requirements mentioned here; http://www.machsupport.com/software/mach3/
Tweakie.