Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Filename	Downloads	Message	Posted
LOOP TEST CODE_HCIR.jpg	416	MISSING STEPS HCIR	February 27, 2011, 04:57:48 PM
cncameteur_hcir.dxf	322	Re: Cutter compensation issues...	March 07, 2011, 06:12:22 PM
cncametuer_hcir.jpg	600	Re: Cutter compensation issues...	March 07, 2011, 06:12:22 PM
NLS_HCIR 1.jpg	744	Re: THE LATHE PROJECT - 2011	March 20, 2011, 08:48:32 PM
MACH & FEED RATES.pdf	629	Re: 4th axis setup	March 29, 2011, 04:57:17 PM
RADI COMMENT_HCIR.jpg	446	Re: Issue with offset	March 30, 2011, 07:20:19 PM
CB_CONE ON STOCK_HCIR 1.jpg	340	Re: I Wish There Was A Wizard For This!	April 17, 2011, 07:29:58 AM
CB_CONE ON STOCK_HCIR 2.jpg	436	Re: I Wish There Was A Wizard For This!	April 17, 2011, 07:29:58 AM
tailstock_HCIR.jpg	502	Re: Restore Lathe Tailstock	April 19, 2011, 05:22:00 PM
vmr NEWFLANGE2.dxf	184	Re: Problems with circles and plines	April 21, 2011, 06:03:36 PM