3711
General Mach Discussion / Re: Mach3, Proma THC, and Gecko540 - Max CL Mode
« on: November 26, 2013, 01:42:42 PM »
Here is the info on MaxCL, basically it is a mode in Mach that pre-configures the I/O so that it specifically matched up to what the MaxCL machines required, so you can not choose which pins do what.
Here is a link to the doc on the ftp site
ftp://machsupport.com/Extra%20Information/MaxNCCL.txt
Hood
Here is a link to the doc on the ftp site
ftp://machsupport.com/Extra%20Information/MaxNCCL.txt
Hood