831
General Mach Discussion / Re: Mach3 Gcode movement help
« on: September 29, 2020, 02:28:51 AM »
then i expect, that there is a M6Tsomething at the beginning of your code.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
%
G21 G40 G00 G99 G17
G0 Z10 (lift z-up)
G0 X10 Y10 (go to drill position)
M3 S1000 (spindle on with higher speed for the drilling)
G1 Z-5 F100 (drill the hole)
M3 S100 (Slow spindle down to tap speed)
G84 X10 Y10 Z-10 R10 L1 F50 (tap and debur)