81
General Mach Discussion / Re: Manual Tool Change with TTS
« on: November 05, 2013, 09:23:52 AM »
Tool changes are done with M6Tn. G43 simply applies the length offset.
Regards,
Ray L.
Regards,
Ray L.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
In general, when a motor is stalled the current goes to infinity and would burn it up as all the energy is going to heat.
So when a stepper stalls max available current is delivered, in your case 10 amps +- ........... depends on the fuse on when it will actual blow.
its only gess work about the weight of the gantry but its cast iron it will be between 200-300kg
Ray the latest version allows you to set the corner speed based on parameters of the corner.
Just a thought (;-) TP
I have a look at gecko manual, I found that there are only to ENC pin, the first is ENC ground the second is ENC 5VDC.
is it one of thèses pins you are tellimg me?
thanks
Robhi
ENC Gnd.