Right now I am not sure what it is. I am trying to narrow down and understand what Mach 4 is doing better.
It is strange that it reads a bore within .0001, but has trouble with edge finding accurately. If anyone has some suggestions on methodically narrowing it down to where the issue is that would be great.
At this point I am not sure if it is in the probe, the machine (the amount of real backlash), the motion controller (ESS), or something else.
I do have a second wild horse probe that is being used as a tool setter. I hate to mess with it because I have it all dialed in and the height set. If I don't figure something else out, I guess I could set that one up as a 3D probe and see how it differs in results.
Or, I could buy another probe that might be better than a Wildhorse and try that, but I am not sure what would be better and within a reasonable price frame?