5501
Mach4 General Discussion / Re: Mach4 Button OFFLINE
« on: January 23, 2018, 06:35:47 PM »
Hi,
does your CSIMO plugin identify what pin is used to enable the servos?
Unless the OSIG_ENABLE0 is assigned to a pin you wont see if the macros have any effect. You need to find what
Mach output signal is attached to the pin/pins that enable your servos.
Craig
does your CSIMO plugin identify what pin is used to enable the servos?
Unless the OSIG_ENABLE0 is assigned to a pin you wont see if the macros have any effect. You need to find what
Mach output signal is attached to the pin/pins that enable your servos.
Craig