Messages

1851

General Mach Discussion / Re: Systrium card controler...????

« on: December 18, 2006, 09:12:54 AM »

nope

1852

General Mach Discussion / Re: error messages

« on: December 18, 2006, 09:10:57 AM »

You know I don't think that we did DRO's just to show the distance to go... I knew there was something that we didn't do ;(

Should be added soon

1853

General Mach Discussion / Re: Anyone else having a problem with wizards in ver 2.026 ??

« on: December 18, 2006, 09:08:55 AM »

What wizard are you running? I will test it here and see what i get

1854

General Mach Discussion / Re: Edge Probing

« on: December 18, 2006, 09:07:41 AM »

Only G31...  and that is where the problem comes in for probing the outside of the part.. you need to calc the vector that the part is headed in and predict where you should hit the part. It is not as simple as you think  but it can be done (It would be way cool to have that on a router! )

1855

Feature Requests / Re: Safe Z on Feedhold

« on: December 17, 2006, 10:46:17 PM »

Not going to happen on a feedhold Stop only...

1856

Feature Requests / Re: Remove buffered outputs

« on: December 17, 2006, 10:45:02 PM »

In that case put in an LED that tells that that macro is running. So the first time that you run the macro it looks to see that that the macro LED is not on, then it starts doing it's thing and is not finished... The user pressed the button again and because the LED is on it exits the macro.

As you can see this will take care of the button being pressed two times in a row.. You just need to be sure that you turn the LED off when you finish the macro that you are running.

Is that any help?

1857

General Mach Discussion / Re: Interesting problems.

« on: December 17, 2006, 10:38:52 PM »

The problem with the A axis should not be there in the latest rev.. if you find that it still is please mail me off list with your XML and small section of code that is giving you trouble.

Thanks
Brian

1858

General Mach Discussion / Re: max feed rate?

« on: December 17, 2006, 10:26:01 PM »

Post your XML and we will see what is going wrong here...

1859

General Mach Discussion / Re: error messages

« on: December 17, 2006, 10:24:33 PM »

The button should read "Distance to Go" It is the amount that each axis must move to finish the Block of code that it is on.

1860

General Mach Discussion / Re: Edge Probing

« on: December 17, 2006, 10:20:02 PM »

Scott it could be done but there is no time to get into a project like that   Try the teach wizard and I think you will find that it is a fast way to do what you are looking to do... Just not with a probe...

Thanks