Messages

61

Galil / Re: Mach3 + Galil

« on: June 29, 2008, 03:49:37 PM »

Pid are set... Can move with camsoft...

62

Galil / Re: Mach3 + Galil

« on: June 29, 2008, 02:35:24 PM »

Ok  this is all I can think of....
Please point me in the right direction...

63

Galil / Re: Mach3 + Galil

« on: June 29, 2008, 02:34:06 PM »

Well I am not getting any motion... Maybe I have something wrong... Please look at the screen shots and PLEASE advise....

64

Galil / Re: Mach3 + Galil

« on: June 29, 2008, 12:20:00 PM »

The I/O is on Port#1, Pin# = the I or O number on the Galil.
Does this stand true with all galil pins? for the motors and endcoders???

cause I am lost? I have 6 wire encoders plus power leads to the motors?
like ya+   ya-   yb+   yb-   encoder + encoder -  ?

65

LazyCam (Beta) / Re: "Z" Plunges Opposite Dir.

« on: June 29, 2008, 09:50:55 AM »

You may need to update lcam? it should not loose that information...

66

LazyCam (Beta) / Re: "Z" Plunges Opposite Dir.

« on: June 29, 2008, 09:49:52 AM »

I ment post processor somewhere?

67

LazyCam (Beta) / Re: "Z" Plunges Opposite Dir.

« on: June 29, 2008, 09:49:05 AM »

Never used lcam... but how do the fixture offsets work?
Can you set a bottom somewhere else?
Could it be in the post somewhere?
How about reverse posting? Can your program do that? Its like mirror...
How about Scaleing in Lcam? Can it do that?

Mine can do this stuff and if you get a little something outa whack its hard to find...

I opend it with both NCPlot and Rhino, it was at Z0 so thats ok...

68

LazyCam (Beta) / Re: "Z" Plunges Opposite Dir.

« on: June 29, 2008, 09:26:30 AM »

N35 G0  Z1.0000
N40 M3 S3000
N45  X2.0000  Y1.5001
N50  Z-1.1000 Is this correctN55 G1  Z0.5000  F20.00 I think this is where you start to cut?N60 G3  X3.5000  Y1.5000  I0.7500  J-0.0001  F66.00
N65  X2.0000  Y1.5001  I-0.7500  J0.0000
N70 G0  Z1.0000
N75  X0.5000  Y3.2501
N80  Z-1.1000 Is this correct

69

LazyCam (Beta) / Re: "Z" Plunges Opposite Dir.

« on: June 29, 2008, 09:12:11 AM »

What does the posted G code look like??

70

LazyCam (Beta) / Re: "Z" Plunges Opposite Dir.

« on: June 29, 2008, 07:53:16 AM »

I can not open your file but....

1 if you have not changed your machine then you have the incorrect goto... another words should be Z-0.250 (maybe is Z0.250)
2 you have changed your mach config...

check these first...