I don't know where exactly to put in the z offset to account for the floating head offset it's .065 I know to goto config.-homing/limits but I don't know which line to put it in. I'm cutting a tear shaped part out of 3/8" steel with a 3/4 hole in the center when it cuts the hole it dives the torch into the metal but it cuts the outer pretty good. I don't have any offset in the program I'm using sheetcam with the proper pierice height them after pierice it dives into the metal for the whole circle then it adjusts quickly to cut the outer. Am I doing something wrong? other than the z offset. Thanks.