1
General Mach Discussion / Re: Motor Turning Errors
« on: March 16, 2018, 03:14:03 PM »
G0 commands work as expected.
Seems my problem is with the Jogging.
X axis jogs ok.
Y axis
When set with 400 unit/min velocity and 2 unit/min acceleration will job at almost 1600 unit/min
When I change the acceleration to 5 it will jog at clost to 800 unit/min.
When I change the acceleration to 10 or higher, it will job at 400 unit/min.
Seems my problem is with the Jogging.
X axis jogs ok.
Y axis
When set with 400 unit/min velocity and 2 unit/min acceleration will job at almost 1600 unit/min
When I change the acceleration to 5 it will jog at clost to 800 unit/min.
When I change the acceleration to 10 or higher, it will job at 400 unit/min.