2941
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: March 03, 2017, 01:35:31 AM »Quote
The issue is, I have saved the g-code from v-carve pro, loaded it in mach 3 but only part of the g-code transfers and I can only see that part in the display.
Hi Vballsave,
Welcome to the forum.
Sounds like you are operating Mach3 in Demo mode where it will only load and run 500 lines of Gcode. You need to purchase and install the license to gain full and unlimited operation of Mach3. http://www.machsupport.com/shop/mach3/
Tweakie.