971
General Mach Discussion / Re: Control Panel running, Machine is not..HELP
« on: April 07, 2016, 05:12:07 PM »
If you loaded software that came with the ports that may be the issue, it is best to let windows find them itself.
Also what operating system are you using? Mach will only run with a 32bit operating system when using the parallel port, if you want to use a 64bit OS then you need an external motion controller of which there are many.
There is an exe in the Mach3 folder which will look at system resources and write a text file report, if your ports are there it may show you the address you need to enter into Mach.
I think the exe is called GetPort or something similar.
Hood
Also what operating system are you using? Mach will only run with a 32bit operating system when using the parallel port, if you want to use a 64bit OS then you need an external motion controller of which there are many.
There is an exe in the Mach3 folder which will look at system resources and write a text file report, if your ports are there it may show you the address you need to enter into Mach.
I think the exe is called GetPort or something similar.
Hood