13411
General Mach Discussion / Re: Help ! "Radial Cut with Zdepth" toolpath from mastercam makes Skip steps ??
« on: January 05, 2011, 02:15:01 AM »
Obviously the xml you attached is not the same one you are using as look ahead is 20 and kernel is 25KHz in it.
Setting the Kernel to 100KHz is not a good thing to do if you dont need it and from your steps per unit you could run no problem at 25KHz so probably best you try that.
Also if you can attach the correct xml it may help if there are config issues.
Hood
Setting the Kernel to 100KHz is not a good thing to do if you dont need it and from your steps per unit you could run no problem at 25KHz so probably best you try that.
Also if you can attach the correct xml it may help if there are config issues.
Hood