8961
General Mach Discussion / Re: dual arm control
« on: February 19, 2009, 09:05:49 AM »
Hi Ben,
Whilst Mach is capable of controlling 6 Axis the software to produce the necessary GCode for positioning and controlling your two arms would be extremely specialized. I have no knowledge of any such available software so I think you would have to write your own GCode for anything you intend to produce. Simple stuff is OK but you would have to be extremely serious to write GCode from scratch for complicated products.
Tweakie.
Whilst Mach is capable of controlling 6 Axis the software to produce the necessary GCode for positioning and controlling your two arms would be extremely specialized. I have no knowledge of any such available software so I think you would have to write your own GCode for anything you intend to produce. Simple stuff is OK but you would have to be extremely serious to write GCode from scratch for complicated products.
Tweakie.