1
General Mach Discussion / Re: Z axis is dead
« on: April 02, 2009, 11:38:41 AM »
It is handheld controller externally from mach3.
Anyways I solved the problem reading through some older posts.
It was the serial cable. I bought a new one and everything was back in order!
It seems that only pin 16 (Z for SyilX4) was damaged.
Thank you
Anyways I solved the problem reading through some older posts.
It was the serial cable. I bought a new one and everything was back in order!
It seems that only pin 16 (Z for SyilX4) was damaged.
Thank you