2451
General Mach Discussion / Re: problems with machining holes and Z axis
« on: October 12, 2017, 02:16:29 AM »
Hi zxrjohn14,
Can you please attach your <profile> .xml file (the one from your Mach3 folder) then we can check all your Mach3 settings. Copy and rename the file to zxrjohn.xml before attaching using the Additional Options tab. Your profile is shown bottom right of the main Mach3 screen.
Assuming you are now using Mach3 version .062 (as suggested) then I suspect the problem is not Mach3 related but all down to your machine mechanicals, however, checking your set-up is prudent as the first step.
Tweakie.
Can you please attach your <profile> .xml file (the one from your Mach3 folder) then we can check all your Mach3 settings. Copy and rename the file to zxrjohn.xml before attaching using the Additional Options tab. Your profile is shown bottom right of the main Mach3 screen.
Assuming you are now using Mach3 version .062 (as suggested) then I suspect the problem is not Mach3 related but all down to your machine mechanicals, however, checking your set-up is prudent as the first step.
Tweakie.