Hi.
I have a strange problem with 0-10 V analog output ( pwm PIN 17 ) on PoKeys 57CNC board.
I configured X, Y, Z, - works fine, then I conneted to relay 1 and 2 direction signals to VFD ( I activated M3 and M4 function to switch output #1 and #2 and mapped this output in Pokeys plugin to Relay outputs. ) this also works good. Then connect 0-10 V analog output ( pwm PIN 17 ) to VFD and configured in Pokeys plugin config pin 17 in PWM output. I mapped this pin as DRO 817.
Strange things happen when a move X axis. When I move X axis in "+ direction" voltage measured 0-10 V analog output increases, when I move X axis in "i direction" voltage measured 0-10 V analog output decreases.
Does anyone know where the problem might be?