231
General Mach Discussion / Another Turn Tool Table question
« on: November 20, 2013, 02:25:11 PM »
I have my tool table set up pretty well now and the diameters I ask Mach to give me come out pretty close as I change amongst the various tools. For whatever reason; metal type, me, the machine, alignment of the planets, etc. the work will occasionally come out under or oversize more than I'd like.
If the work comes out oversize by say .004", and Mach is set up in the Diameter mode, do I change the X Offset by .004" or .002" in the Tool Table Editor? Subtract the correct value or add it?
If the work comes out oversize by say .004", and Mach is set up in the Diameter mode, do I change the X Offset by .004" or .002" in the Tool Table Editor? Subtract the correct value or add it?