5931
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: November 13, 2017, 05:55:00 PM »
Hi,
welcome. Sounds like the Gcode is in inches but your machine is in mm, so the part comes out 1/25 th of real
size. Try MDIing G20 and then run your code again. G20 signals Mach that the current program is to be interpreted
in inches.
Craig
welcome. Sounds like the Gcode is in inches but your machine is in mm, so the part comes out 1/25 th of real
size. Try MDIing G20 and then run your code again. G20 signals Mach that the current program is to be interpreted
in inches.
Craig