Welcome, Guest. Please login or register.
Did you miss your activation email?
April 16, 2014, 10:58:56 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Newfangled Solutions Mach3 Wizards (Moderator: Ron Ginger)
| | |-+  I need help with Shapes Wizard
Pages: « 1 2   Go Down
Print
Author Topic: I need help with Shapes Wizard  (Read 2251 times)
0 Members and 1 Guest are viewing this topic.
Overloaded
Global Moderator
*
Online Online

Posts: 3,896



View Profile
« Reply #10 on: December 22, 2010, 10:53:51 AM »

Hi Fred, I had the same problem as you.
Even though you are set to CONTOUR, for some reason the Horizontal Offset still needs to be < the cutter dia.
To make it "stick", I had to go to the MATERIAL (sorry) "STOCK"page, make the entry, hit enter then SAVE SETTINGS before going back to the SHAPES page.
Then it all worked OK for me.
Hope it will for you as well.
If not, we'll try something else.
Good luck.
« Last Edit: December 22, 2010, 10:55:30 AM by Overloaded » Logged

"I haven't failed. I've just found 10,000 ways that won't work."         Edison

"You cannot help men permanently by doing for them what they could and should do for themselves."
Abe Lincoln
Pages: « 1 2   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!