Welcome, Guest. Please login or register.
Did you miss your activation email?
September 20, 2018, 04:14:55 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  FAQs
| | |-+  Laptop requirements with Mach 3
Pages: « 1 2 3 4   Go Down
Print
Author Topic: Laptop requirements with Mach 3  (Read 48391 times)
0 Members and 1 Guest are viewing this topic.
Woodcutter
Holding

Offline Offline

Posts: 1


View Profile
« Reply #30 on: October 04, 2016, 06:28:27 PM »

The Newfangled Solutions web site for Mach3 software identifies a system requirement for "Non-integrated Video Card with 32MB RAM".  What are the technical or performance issues with an integrated video card when running Windows 7?
Logged
Tweakie.CNC
CNC is only limited by our imagination.
Global Moderator
*
Offline Offline

Posts: 7,400


Super Kitty


View Profile WWW
« Reply #31 on: October 05, 2016, 12:06:34 AM »

Quote
What are the technical or performance issues with an integrated video card when running Windows 7?

It depends on the architecture of the particular computer (some will work OK whilst others will not thus the recommendation by NFS) but the most common issue, I have found, is program flow (freezing) when running long Gcode files.

Tweakie.
« Last Edit: October 05, 2016, 01:27:38 AM by Tweakie.CNC » Logged

Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
stragenmitsuko
Active Member

Offline Offline

Posts: 7


View Profile
« Reply #32 on: July 06, 2018, 04:07:45 AM »

Laptop : HP Compaq NC6000 Pentium M
OS :  XP-SP3 .

Could not be  used , not even close , timing all over the place steppers buzzing and humming ...
I turned off everything I could think of , both in the bios and in the OS , no avail , altough I did
get some improvement .  

I was ready to give up and install a desktop , when  I found this thread .
Changed ACPI to std PC and like magic  Smiley
the system is now rock stable .
 
Big thanks for sharing this information , I would never have found it on my own .

Pat
Logged
Pages: « 1 2 3 4   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!