Hi Ron, How is it going? I went to use the surfacing wizard today and found it did not work.
I input all the data but it would not preview, or post or even let me out. I had to shut down mach in order to get out.
If you could check it out on your end. I have the latest version NFW and the latest Mach 3.04.
If it would help When I get time I can go through all the wizards and test them again.
The least I could do as much as I use them to build programs.
Also if you get time could you install a spindle speed selection DRO in the Power Feed wizard? Now that I have uncrippled the wizard by fixing my macro pump(;-) it is a handy dandy wizard again. Also could you install a cancel or stop button??
Thanks (;-) TP