Welcome, Guest. Please login or register.
Did you miss your activation email?
October 21, 2018, 09:07:48 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  HiCON Motion Controller (Moderator: Vital System Support)
| | |-+  HiCon Plug Crash
Pages: 1   Go Down
Print
Author Topic: HiCon Plug Crash  (Read 193 times)
0 Members and 1 Guest are viewing this topic.
Boots
Active Member

Online Online

Posts: 11


View Profile
« on: October 06, 2018, 04:53:53 PM »

Install Hicon Intergra 7766 with 7377 Hicon plugin crash

System: Dell Precision, Windows 7, 7766, 7377 boards, Mach4 install

When I try to configure HiCon Device (Config>Select Motion Device) it comes up with an error: Config Data not Initialized or Corrupt. Then in goes to the Dos screen and says "Configuration Download Success" Then it closes Mach4.

When I Re-start Mach4 and run VSI Device Manager and then San the Network is shows the correct IP connection. HiCon is also shown in the window below. I also enabled "J7 step and Direction" and clicked Download. But it still crashes.  Huh

?? Could uses some help, Boots-2b1
Logged
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!