Welcome, Guest. Please login or register.
Did you miss your activation email?
August 14, 2018, 07:54:04 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  VB and the development of wizards
| | |-+  TEXT user controls??? (running ATC on RS-232)
Pages: 1   Go Down
Print
Author Topic: TEXT user controls??? (running ATC on RS-232)  (Read 79 times)
0 Members and 1 Guest are viewing this topic.
DerWeisse
Active Member

Offline Offline

Posts: 5


View Profile
« on: August 09, 2018, 03:21:56 AM »

I already asked this with no answer.
I built ATC which works on its own, communicating with MACH3 by serial comm only, not hardware.
I made it send back text strings with every action or error.
I wrote it all inside M6Start and it works great, BUT...
1. The only place I can direct text to is 'message'. I didn't find anything else.
2. If I run the macro by itself, all my text IS SHOWING on the message line (see pic MYMESSAGE). HOWEVER, MACH runs the macro the 'message' show constantly "Press CycleStart after Tool Change".

a) Why?
b) Can I get ANOTHER label or text control so I can show my messages there?

Otherwise the ATC works well. MACH3 is config on "Stop Spindle and Press Cycle Start" but I added DoButtonOEM(1000) and it does the job.

Thanks.


* mymessage.jpg (8.66 KB, 165x65 - viewed 4 times.)
Logged
BR549
Mach4 Alpha

Offline Offline

Posts: 6,853


View Profile
« Reply #1 on: August 11, 2018, 07:17:40 PM »

You should be using (x)  Auto tool changer in config.
Logged
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!