Welcome, Guest. Please login or register.
Did you miss your activation email?
September 20, 2018, 03:57:03 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  SmoothStepper USB (Moderator: Warp9TD)
| | |-+  Ess Reset Velocity N. Disabling mach
Pages: 1   Go Down
Print
Author Topic: Ess Reset Velocity N. Disabling mach  (Read 869 times)
0 Members and 1 Guest are viewing this topic.
Mr. Toad
Holding

Offline Offline

Posts: 1


View Profile
« on: June 18, 2018, 11:57:46 AM »

I built this cnc router and tried to fire it up to drill a series of holes to screw the spoil board to the table. I am using mach4 (the trial version) ESS, the new version and V Carve Pro. A couple of question here: I did a little drawing to lay out the holes, tool path etc. and saved the tool path, when a tool path is saved what file ext. does it save as? Mine saved as a txt. I used that. When I ran that I got a message, "ESS Reset Velocity N. Disabling Mach". What does that mean? 
Logged
Tweakie.CNC
CNC is only limited by our imagination.
Global Moderator
*
Offline Offline

Posts: 7,400


Super Kitty


View Profile WWW
« Reply #1 on: June 19, 2018, 01:07:03 AM »

Hi Mr.Toad,

To avoid duplication this topic is already being dealt with by Andy (the expert) on the Warp9 forum;  https://www.warp9td.com/index.php/kunena/7-general-discussion/7576-woodworker-needs-help?start=36

Tweakie.
Logged

Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!