Welcome, Guest. Please login or register.
Did you miss your activation email?
October 18, 2018, 09:42:51 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  CS-Lab
| | |-+  Problems wit G31/M31 and subs
Pages: « 1 2   Go Down
Author Topic: Problems wit G31/M31 and subs  (Read 925 times)
0 Members and 1 Guest are viewing this topic.
Active Member

Offline Offline

Posts: 869

View Profile
« Reply #10 on: May 16, 2018, 04:20:33 AM »

i allways declare my Global var's so for Example:

Global X_SENS as Double
Global Y_SENS as Double
Global Z_SENS as Double


anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.
Global Moderator
Offline Offline

Posts: 6,016

View Profile WWW
« Reply #11 on: May 16, 2018, 05:36:27 AM »

I don't know why it doesn't work. As I mentioned before, it could be due to your motion controller. Macros can behave differently with different motion controllers.

Mach3 is at the end of it's life. Development stopped over 5 years ago. Documentation was always sparse, so your not going to see any new documentation now.
There is a Cypress manual, and a Mach3 programming manual available to download.

THe Wiki contains 99% of the Button, OEM and DRO numbers. There is a post somewhere here on the forum that may have a few more obscure ones in it, if you search. But the Wiki should have everything you need.

As for the Vars, as I said, they are not documented, except for a few in the manual. I've never seen a list anywhere, and I suspect that only the developers have a full list.


2010 Screenset

JointCAM Dovetail and Box Joint software
Active Member

Offline Offline

Posts: 5

View Profile
« Reply #12 on: May 16, 2018, 12:41:00 PM »

Well then,
That's clear. Thanks for all the help you two. I hope I can come back to you when I run into trouble again.
Pages: « 1 2   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!