Greetings! I'm new here and eager to learn. I have a router I bought ten years ago, never mastered g-code, gave it to my grandson, then retrieved it recently. I'm doing Fusion360 for a 3D printer and think I can generate g-code for the router.
My router has kl23h276-30-8b motors and I'm getting it to run well, I think. However when doing a lot of stepping the motors get hot, about 175F 80C. Is that normal?
Also, when the router stops the motors sometimes are still making a noise, pretty low, but I have to turn the breakout board off to get them to stop, or step them manually to a different location. Do I have a configuration problem?
Thanks in advance for any help.