Author Topic: Testing new Machdrives servo drives  (Read 2713 times)

0 Members and 1 Guest are viewing this topic.

Offline N4NV

  • Active Member
  • Posts: 381
    • View Profile
Testing new Machdrives servo drives
« on: February 12, 2018, 01:10:00 PM »
https://www.youtube.com/watch?v=0uw0qHKbspI

I replaced my ServoDynamics drives (from 1989) with Machdrives https://www.machdrives.com/brc.aspx
I went with Machdrives because my servo motors are 110VDC and they could handle the voltage.  This machine has a 500 pound table.  It doesn't look that big in the video, but the entire knee mill is over 5,000 pounds (a Bridgeport is about 1,800).  It is running at 60 ipm.  Rapids are 300 ipm.  When the machine was new it had an Allen Bradley control system that was limited to 100 ipm rapids and 50K of program size.  But it did have a cassette tape option!

Vince

Offline al3c

  • Holding
  • Posts: 1
    • View Profile
Re: Testing new Machdrives servo drives
« Reply #1 on: May 11, 2018, 07:07:33 AM »
thanks for the share..actually your video help me come up with the solution to one problem i've been having))
best
statistics expert
yourhomeworkhelp.org